Mojoh Ryzer Go
Official Media Guide Official product information, specifications, and usage guidance for press, media, and creators.
At a Glance
Product: Ryzer Go
Sizes: 7" Depth and 9" Depth
Height: 13.7" Height
Category: Universal attachable bag stand
Primary benefit: Keeps bags upright, clean, and accessible
Launch: Kickstarter planned for June 2026
Link: https://ryzer-go-presale.mojohgear.com/
Status: Manufacturing complete. Final pin clutch component in development.
Price: MSRP: $99 - Kickstarter VIPs start at 40% off
Product Overview
Ryzer Go is a universal, attachable bag stand that clamps to most backpacks and tote style bags. It keeps gear off the ground, upright, and easily accessible without requiring a separate stand or extra setup.
Mojoh Gear has been manufacturing and selling a disc golf specific version of the Ryzer for about three years. That experience allowed the team to refine the design, eliminate weak points, optimize materials, and dial in manufacturing processes before expanding the platform into the Ryzer Go product line.
Ryzer Go is launching on Kickstarter around June 2026. Tooling and manufacturing processes are complete. The only remaining component in development is the finger release pin clutch, which will be finalized and fully tooled prior to launch.
A New Way to Use Your Bag Anywhere
- Attaches directly to the bag rather than being a separate stand
- Remains attached during transport and use
- One motion deployment without setting the bag down
- Swappable between multiple bags and use cases
- Stable tripod geometry with minimal added weight
How It Works
Opening the Stand
1- Hold the bag in front of you.
2- Twist the handle to deploy the legs.
3- Set the bag down.
4- On hills, point the two leg side downhill for stability.
Closing the Stand
1- Manually close the legs until they snap into place.
2- Legs can be closed while holding the bag in front of you or while wearing the bag and reaching behind.
Leg Securing Strap A quarter-inch bungee wrapped around the back pad can be looped under the legs and around the handle to prevent the legs from opening during overhead airline storage or other transport.
Video How to use the Ryzer Go
How to Attach
Backpack Attachment
- Install clamps using the pins and clutches on the front of the bag above the mounting straps.
- Mounting straps can be repositioned by loosening screws and moving them to alternate holes for better alignment.
- Attach hangers to the lower portion of the backpack shoulder straps on the back.
- Tighten tension to achieve the most vertical resting position.
- The four connection points only support the weight of the stand and are gentle on your bag.
Tote Style Bag Attachment
- Install clamps and pins on all four corners of the bag above the mounting straps.
- Use additional mounting straps included in the accessories box on the back of the Ryzer.
- The four connection points only support the weight of the stand and are gentle on your bag.
Heavy Duty Attachment Option
- Four plastic screws and nuts are included for heavier duty attachment.
- This option is only needed when heavy contents could damage or bend the smaller pin attachments.
- To use them, place the clamp on the outside of your bag, toolbox, or bucket, then run the screw through the bag material and into the plastic nut on the inside.
Important compatibility note
- Insulated cooler bags should NOT be punctured.
- Use existing pockets if available.
- Use Mojoh G hooks that loop into vertical MOLLE style webbing found on some cooler bags, including certain Yeti models.
- G hooks are not included with the Ryzer.
Video How to attach Ryzer Go
Sizes and Bag Fit Information
Bag Depth Compatibility
- Ryzer Go 7" Depth: Fits bags 5.5 to 9.5 inches deep
- Ryzer Go 9" Depth: Fits bags 8.5 to 12 inches deep
-Bags between 8.5" and 9.5" deep can work with either size. For backpacks, we recommend the 7" Ryzer Go, unless you also plan to use it with deeper bags.
Bag Width Compatibility - Both models support bags approximately 10 to 16 inches wide.
Weight Capacity
- Structurally tested beyond 100 lbs.
- Recommended maximum bag weight for normal use is 50 lbs.
Use Case Categories
- Travel bags
- Laptop and work bags
- Diaper bags
- Photography bags
- Beach bags
- Outdoor and hiking bags
- Fishing bags
- Tool bags
- Medic and EMT bags
- Range bags
- And many more
Materials
- Main structure: ABS technical polymer
- Latches and release mechanism: Acetal technical polymer
- Hardware: Stainless steel screws
- Legs: Aluminum
Weights
- Ryzer Go 7" Depth: 2.3 lbs
- Ryzer Go 9" Depth: 2.4 lbs
What Is Included
- Ryzer Go stand
- Mounting clamps, pins, and clutches
- Mounting straps
- Installation instructions
Warranty
Ryzer Go includes a one year warranty covering manufacturing defects.
Media Downloads
Mojoh Ryzer Go Logos Download logo files (Google Drive)
Media Usage
- Product names: Ryzer Go 7" Depth and Ryzer Go 9" Depth
- Company name: Mojoh
- Reference to www.mojohgear.com
- For assets, review units, or press inquiries, contact Mojoh